Electrical System &
Equipment Inspection
Comprehensive inspection and testing of HV/LV switchgear, transformers, distribution boards, UPS systems, motors, and earthing installations — ensuring electrical safety compliance under IEC and BS standards.
2000+
Systems Tested
EICR
Reports Issued
HV/LV
Full Coverage
IR
Thermal Surveys
Safeguarding People and Assets from Electrical Hazards
Electrical faults cause over 30% of industrial fires and rank among the top workplace hazards globally. Smart Inspection & Certification provides qualified electrical inspections that detect thermal hotspots, insulation breakdown, and installation non-conformities before they trigger arc flash incidents, equipment damage, or power outages.
Our inspection team includes City & Guilds qualified inspectors and FLIR Level II thermographers who perform systematic assessments of switchgear, motors, cabling, earthing, and emergency power systems across industrial, commercial, and marine environments.
Testing Capabilities
- City & Guilds / C&G 2391 qualified electrical inspectors
- NETA / NFPA 70B compliant test procedures
- High-voltage switching, isolation & permit-to-work capability
- Full thermal imaging with FLIR Level II thermographers
- Comprehensive EICR (Electrical Installation Condition Reports)
Inspection Services
Electrical Inspection Coverage
From HV switchgear to earthing systems — complete electrical safety surveying.
HV Switchgear & Transformers
Insulation resistance testing (Megger), transformer oil analysis (DGA), tap changer inspection, bushing condition assessment, and partial discharge surveys.
LV Switchboards & Distribution
Cable termination tightness, busbar joint torque verification, MCB/MCCB trip testing, earth fault loop impedance, and RCD response time assessment.
Thermographic Surveys
Infrared thermal imaging of panels, cables, joints, and transformers to detect overheating, unbalanced loads, and imminent connection failures.
UPS & Battery Systems
Battery impedance and conductance testing, discharge capacity analysis, charger output verification, ATS transfer time testing, and runtime audits.
Motor & Drive Inspection
Winding insulation resistance, vibration analysis, bearing condition monitoring, VFD harmonic measurement, and alignment check for large rotating machines.
Earthing & Lightning Protection
Earth resistance measurement, soil resistivity surveys, down conductor continuity, surge protection device (SPD) testing, and mesh voltage assessments.
